Let's see
KE=1/2mv²m is mass and v is velocity
2KE=mv²4(2)=0.02v²8=2v²/1002v²=800v²=400v=20m/sThis man is jumping through the air what are forces use
Answer:
Thrust / Lift / Gravity
Explanation:
He must create enough force of thrust to jump for a short time and gravity pulls him back down almost immediately.
Answer:
gravity and resistance, the man is moving so the force is unbalanced
Explanation:
The energy diagram shows the changes in energy during a chemical reaction.
Which statement best describes the total energy change of the system?
Potential energy
Reaction progress
A. The products have higher potential energy, and energy is released.
OB. The reactants have higher potential energy, and energy is
absorbed.
C. The products have higher potential energy, and energy is
absorbed
D. The reactants have higher potential energy, and energy is released.
Answer: The Energy Change
Explanation: change for a chemical reaction can either be exothermic if it gives off heat or endothermic if it requires heat to proceed. in a chemical reaction is due to the difference in the amounts of stored chemical energy between the products and the reactants. This stored chemical energy, or heat content, of the system is known as its enthalpy. energy changes that occur during a chemical reaction can be shown in a diagram called a potential energy diagram, or sometimes called a reaction progress curve. A potential energy diagram shows the change in potential energy of a system as reactants are converted into products.
8.54 Three identical balls of mass m are placed in the con-
figuration shown in the
figure. Find the location
(0, a)
of the center of mass.
50
(0,0)
(a,0)
The center of mass is the point located in an average position concerning the objects' positions and their masses. (a/3;a/3) is the location of the COM.
What si the center of mass?
The center of masses of a given system of particles or objects is the position under which all external forces are acting. Any uniform force acts on this point.
This position is the average position of all the components of the system concerning their masses. It can be placed in one, two or three dimensions according to the system.
Coordinate X of the center of masses is given by the following formula,
Xcom = Σ(Ximi) / Σmi
This is the adition (Σ) of each particle position on the X-axis (Xi) multiplied by their mass (mi), and the result divided by the summation of all masses -total mass-.
In the same way, coordinate Y of the center of masses is given by the following formula,
Ycom = Σ(Yimi) / Σmi
This is the adition (Σ) of each particle position on the Y-axis (Yi) multiplied by their mass (mi), and the result is divided by the summation of all masses.
The center of masses is located in the position (X, Y).
According to this framework, we can get the coordinates of the center of masses for this bidimensional system. Coordinates can be expressed in meters or centimeters (m or cm).
Data:
Particle ⇒ (X;Y)
Ball 1 ⇒ (0;a)Ball 2 ⇒ (0;0)Ball 3 ⇒ (a;0)Coordinate X ⇒ Xcom = Σ(Ximi) / Σmi
Xcom = (0m) + (0m) +(am) / m +m +m
Xcom = am / 3m
Xcom = a/3
Coordinate Y ⇒ Ycom = Σ(Yimi) / Σmi
Ycom = (am) + (0m) +(0m) / m +m +m
Ycom = am / 3m
Ycom = a/3
Coordinates of the center of masses, (X;Y) = (a/3 ; a/3)
(a/3 ; a/3) is the location of the center of mass in the proposed bidimensional system.
You can elarn more about the center of mass at
https://brainly.com/question/8662931
https://brainly.com/question/13123609
The mass of a body is 25 kg and the value of acceleration due to gravity is 9.8 m/s2. Calculate the weight of body
Explanation:
[tex]w = mg \\ w = 25kg \times 9.8 \frac{m}{s} ^{2} \\ w = 245\\ [/tex]
How does a mutation in a gene affect a protein?
Answer:
a variant can cause a protein to malfunction or to not be produced at all.
How is thermal energy transferred during conduction? check all that apply.
Answer:
Conduction is the process by which heat energy is transmitted through collisions between neighboring atoms or molecules
Explanation:
Seeds are often found on which part of a gymnosperm?
branch
leaf
cone
stem
Which two types of electromagnetic waves have higher frequencies than the waves that make up ultraviolet light?
Answer:
the answer is equal to the wave make up ultraviolet light.
Light of frequency 2.5 x 1015 Hz illuminates a
piece of iron, and the iron emits photoelectrons
with a maximum kinetic energy of 6.3 eV. What is
the threshold frequency of the metal? Planck's
constant is 6.63 x 10-34 J·s.
.
Answer:
h f = W + KE
Input energy equals work function plus KE of emitted electron
W = 6.63E-34 * 2.5E15 - 6.3 * 1.6E-19
W = 6.63 * 2.5 * 10^-19 - 10.1 * E-19 ev (1ev = 1.6E-19 J)
W = (16.6 - 10.1)E-19 = 6.5E-19 J
h f = 6.5E-19 J for electrons to be emitted with zero KE
f = 6.5E-19 / 6.63E-34 = .98E-15 / sec = 9.8E-14 / sec (threshold)
The process of going from having work done by muscle to being done by machines is: ________-
Answer:
Mechanization perhaps
Explanation:
What’s the difference between jumping with ur leg straight and ur leg bend
How does your Liver work with your Bladder in your body?
Answer:
The liver filters the blood of toxins before it continues through the body. It also removes excess sugar from the arteries. Your kidney then further filters the blood for water-soluble waste and toxins to be excreted and finally, your bladder gets read of that water-soluble waste.
In an experiment for measuring the speed of sound gun was shot 715 m away from the observer. It was heard 2. 13 seconds after the flash was seen. What was the speed of sound in air at that time?
The speed of the sound wave after the flash was seen, in the experiment for measuring the speed of sound gun is 110 m/s.
Speed of the sound waveThe speed of the sound wave can be determined by applying the principle of echoe as shown below;
v = 2d/t
where;
d is the distance of the sound wavet is time of motionv = (2 x 715) / (13)
v = 110 m/s
Thus, the speed of the sound wave after the flash was seen, in the experiment for measuring the speed of sound gun is 110 m/s.
Learn more about speed of sound here: https://brainly.com/question/15211242
What are some examples of why parallel circuits are good for everyday life?
Explanation:
Parallel circuits are used in wiring almost everything in buildings. You use them to turn on the lights in a room, Use a blow dryer, or plug anything into an outlet
A car is traveling at a speed of 9.88 m/s. It travels for 9.71 seconds. what distance did the car travel
Answer:
it should be 21,3 kilometer
What is the amount of work needed to lift a book weighing 20.0n a distance of 2.0m
Answer:
w = 40 Joules
Explanation:
Formula to get work:
W = F × S
where:
w = work/Joules
F = force/newtons
s = displacement/meters
substitute:
w = 20 × 2
w = 40J
True or False [2 pts]: As the distance d between a planet and a moon is increased, the strength of tidal forces decreases linearly (i.e., the strength of tides scales as 1/d).
It is true that as the distance d between a planet and a moon is increased, the strength of tidal forces decreases linearly (i.e., the strength of tides scales as 1.
What is Tidal force?.Tidal force is the gravitational force that a body on a linear motion experiences which pull the body towards the center of the mass of another varying body because of the gravitational pull of that body at a distance.
Therefore, It is true that as the distance d between a planet and a moon is increased, the strength of tidal forces decreases linearly (i.e., the strength of tides scales as 1.
Learn more about tidal force below.
https://brainly.com/question/6762160
how do you find spring constant from a weight (n) vs displacement (m) graph?
Answer:
Explanation:
The slope of the graph is the spring constant n/m
Is cereal consider soup?
Answer:
Explanation:
I guess so because it has ingredients such as froot loops, frosted flakes, and such plus its liquid.
he electric motor of a model train accelerates the train from rest to 0.720 m/s in 29.0 ms. The total mass of the train is 840 g. Find the average power delivered to the train during its acceleration. W
Answer:
7.481W
Explanation:
power= work done÷time
power= force × uniform velocity
a= ∆v/t
29.0ms=
[tex]29 \times {10}^{ - 3 } s [/tex]
=(0.72-0)÷29×10^-3
a=24.83m/s^2
Newton's second law
f=ma
=(0.84×24.83)
=20.86N
w=FD
v^2=u^2+2as
0.5184=0+49.66s
s=0.0104m
20.86×0.0104
=0.216944J
0.216944÷t
P=7.481W
Which two statements about kinetic energy are true
a. It provides heat because heat is also related to kinetic energy.
b. It is found only in living things.
c. Its amount depends on the moving object's speed.
4. Which TWO images below show kinetic energy?
PLEASE HELP!!!
Answer:
A, C
Explanation:
It can be found in objects like a swing. It creates kinetic energy when it is coming back or going away, while moving.
A baseball is flying through the
air at 40 m/s east. This
measurement represents the
ball's
A. speed
B. velocity
C. inertia
D. force
Answer:
b
Explanation:
it indicate direction of baseball
6. The star nearest to our Sun is Alpha Centauri, which is 4.3 light years away. A light
year is the distance that light travels in one year. 1 light year is about
9,500,000,000,000kilometers. Again, use the unit cancelation technique:
How many astronomical units is it to Alpha Centauri? HELP
Answer:
273,000 Astronomical Units.
Explanation:
4.3 light years = 40,850,000,000,000 kilometeres, 4.3 x 9,500,000,000,000.
Convert kilometers to astronomical unit:
149,597,870 kilometers = 1 AU, convert unit.
40,850,000,000,000 divided by 149,597,870 = 273,065.385222 or approx. 273,000 AU.
A wave has a frequency of 20.0 Hz and a velocity of 5.0 m/s. What is its wavelength?
Answer:
0.25 m
Explanation:
λ = v/f
I hope it helped you
The first spacecraft to make detailed maps of the galilean satellites of jupiter was/were.
Answer:
Voyager 1 and 2
Explanation:
Which of the following affects the strength of electric attraction/repulsion more: The magnitude of the charge or the distance between them?
(Standard SPS10 c)
A. The magnitude
B. The distance
C. Neither. They affect the strength the same amount ос
Answer:
Distance between them (r^2 )
Explanation:
F = C q1q2/r^2
How do you know where the centre of curvature(c) and the focal point(f) is on the principle axis
Answer:
C is radius of sphere
Explanation:
F is C/2
what must be the acceleration of a box that is pushed with 86N of force and experiences 29N of friction? The mass of the box is 5kg
F_net:-
86N-29N57NNow
Apply Newton's second law
F=ma57=5aa=57/5a=11.4m/s²When the north pole is tilted toward the sun, which area has the fewest hours of daylight?.
Answer:
The earth revolves around the sun in a plane called the ecliptic.
The poles of the earth are at an angle of about 23.5 deg from the ecliptic.
If the north pole is tilted at 23,5 deg towards a perpendicular to this plane (ecliptic) the south pole will be tilted at 23.5 deg away from this plane and will receive the least amount of sunshine.
This is called the summer solstice in the northern hemisphere. and occurs around June 21.
Can anyone help me?
Answer:
option d is your answer
Explanation:
you can find the complete solution in the given attachment
I hope it helped you